Test Monitor Message Reference
MegunoLink identifies commands for the test monitor panel commands from specially formatted messages in serial streams. Each command must be surrounded by braces (‘{‘ and [...]
Arduino Programming Hardware Support
MegunoLink comes pre-configured with support for programming a number of devices using a serial port or in-circuit serial programmers. Please contact us if you don’t see your device listed [...]
Give your Devices Unique Ids
MegunoLink’s EEPROM Id Writer panel in the Program Devices visualizer lets you easily write unique Ids to your Arduino devices. A unique Id is useful when several devices are communicating [...]
Download Arduino Program/EEPROM
The Downloader panel in the Program Devices visualizer lets you download Arduino program memory (FLASH) or EEPROM memory stored on an Arduino into a .hex file. Downloading device data helps you [...]
Test Monitor Panel
The Test Monitor panel lets your Arduino program report the results from simple self tests in the Program Devices visualizer. It can be used stand-alone, or as part of a serial programming [...]
Programming Sequences
Programming sequences let you run all the enabled programmers in a Program Devices visualizer in parallel or series. Running in parallel starts all programmers at the same time. Running in series [...]
Start External Program
The Start External Program panel in the Program Devices visualizer lets you run an external program to program your device. The external program could use 3rd party software to configure, program [...]
